What is it about?

When drilling the superalloy Inconel 718 twist drills are faced with high thermomechanical loads. Owing to the low thermal conductivity of the workpiece material a large amount of the generated heat has to be transported away from the tool by the coolant. In this paper, the influence of the coolant pressure and the diameter of the coolant channels have been studied. The experiments have been supported by using computational fluid dynamics (CFD) simulations and were focused on the tool wear and the bore quality. The CFD simulation is a valuable tool which supported the present investigation, that a higher mass flux has no advantage regarding tool life and bore quality; moreover, the modification of the channel diameters has not reduced the thermal loads. In all investigated processes, dead zones near the cutting edge and the counter edge could not be reduced by increasing the flow rate. Only by the use of higher coolant pressures, the tool life could be significantly increased, as well as the bore quality.

Featured Image

Why is it important?

The investigations prove that especially when metrological methods reach their limits, the CFD is a suitable tool; which supports the design process effectively by giving a better insight into the coolant flow resulting from the complex drilling processes.


Innovation with use CFD in machining processes

Dr. Ekrem Oezkaya
Turk-Alman Universitesi

Read the Original

This page is a summary of: Experimental studies and CFD simulation of the internal cooling conditions when drilling Inconel 718, International Journal of Machine Tools and Manufacture, September 2016, Elsevier,
DOI: 10.1016/j.ijmachtools.2016.06.003.
You can read the full text:




The following have contributed to this page