All Stories

  1. Magnetite-Based Resistor for Nitric Oxide Detection
  2. Microcantilever Printed Back-to-Back ZnO Single-Nanowire Schottky Diodes
  3. Two-Dimensional MoS2-Based Electrochemical Biosensor for Highly Selective Detection of Glutathione
  4. Gas Sensors Based on Drop-Casted ZnO Nanowires and Micro-Cantilever Printed Ag Contacts
  5. Single Bit-line 11T SRAM Cell for Low Power and Improved Stability
  6. Fabrication and Electrical Characterization of Printed Microresistors of Silver Nanoparticles Using Microcantilever-Based Printing Technology
  7. Adsorption of Urea over Transition Metal-Doped Graphene: A DFT Study
  8. Transition Metal Dichalcogenide-Based Field-Effect Transistors for Analog/Mixed- Signal Applications
  9. Adsorption of Phosgene on Titanium Doped Graphene Nanoribbons: A DFT Study
  10. Wide Bandgap Zinc Oxide Thin Films Prepared by RF Magnetron Sputtering at Room Temperature
  11. Analysis of Superfine-Resolution Printing of Polyaniline and Silver Microstructures for Electronic Applications
  12. Simulation Studies on ZnO Nanoparticle Based FET Device for Possible Biosensing Applications
  13. Adsorption of gaseous air pollutants over Ti-doped ZGNR structures: a DFT study
  14. Modeling of graphene-based field-effect transistors through a 1-D real-space approach
  15. Low-Power Digital Baseband Transceiver Design for UWB Physical Layer of IEEE 802.15.6 Standard
  16. On-Chip Photovoltaic Power Harvesting System With Low-Overhead Adaptive MPPT for IoT Nodes
  17. Efficient Solar Power Management System for Self-Powered IoT Node
  18. Detection of Glutathione by Glutathione-S-Transferase-Nanoconjugate Ensemble Electrochemical Device
  19. Performance Evaluation of Bilayer Graphene Nanoribbon Tunnel FETs for Digital and Analog Applications
  20. Message from the conference patron
  21. Adsorption of CO and NO on Ti-doped ZGNR structures: A DFT study
  22. The effects of backbone fluorination on photovoltaic properties of polymers of thiophene, selenophene and tellurophene and their hexyl derivatives: A DFT study
  23. Impact of active well biasing on process-induced variations of a bulk planer junctionless transistor
  24. Performance projection of bilayer graphene nanoribbon FET through quantum mechanical simulation
  25. Analysis and design of moderate inversion based low power low-noise amplifier
  26. Multi-standard high-throughput and low-power quasi-cyclic low density parity check decoder for worldwide interoperability for microwave access and wireless fidelity standards
  27. An Efficient On-Chip Switched-Capacitor-Based Power Converter for a Microscale Energy Transducer
  28. Opening remarks
  29. An Efficient on Chip Power Management Architecture for Solar Energy Harvesting Systems
  30. Design and Implementation of Blind Assistance System Using Real Time Stereo Vision Algorithms
  31. Design and Implementation of Low-Power Digital Baseband Transceivers for IEEE802.15.6 Standard
  32. Power Optimization of LNA for LTE Receiver
  33. A New PVT Compensation Technique Based on Current Comparison for Low-Voltage, Near Sub-Threshold LNA
  34. Memory-Reduced Maximum A Posteriori Probability Decoding for High-Throughput Parallel Turbo Decoders
  35. VLSI Design and Hardware Implementation of High-Speed Energy-Efficient Logarithmic-MAP Decoder
  36. Analysis of Graphene Tunnel Field-Effect Transistors for Analog/RF Applications
  37. A surface-potential based drain current model for short-channel symmetric double-gate junctionless transistor
  38. A low-power subthreshold LNA for mobile applications
  39. An efficient on-chip energy processing circuit for micro-scale energy harvesting systems
  40. Analysis of nanowire transistor based nitrogen dioxide gas sensor – A simulation study
  41. High-Throughput LDPC-Decoder Architecture Using Efficient Comparison Techniques & Dynamic Multi-Frame Processing Schedule
  42. Design of an osmotic pressure sensor for sensing an osmotically active substance
  43. The effect of high-k gate dielectrics on device and circuit performances of a junctionless transistor
  44. Hardware Implementation and Testing of Log-MAPP Decoder Based on Novel Un-grouped Sliding-Window Technique
  45. Impact of fringing fields in a p-channel junctionless transistor
  46. Performance improvement of square microhotplate with insulation layer and heater geometry
  47. Fabrication and Testing of an Osmotic Pressure Sensor for Glucose Sensing Application
  48. Comparative Study of Simplified MAP Algorithms and an Implementation of Non-Parallel-Radix-2 Turbo Decoder
  49. A 0.5-V low power analog front-end for heart-rate detector
  50. High-Throughput Turbo Decoder With Parallel Architecture for LTE Wireless Communication Standards
  51. An efficient hardware architecture for stereo disparity estimation
  52. Design and implementation of multi-rate LDPC decoder for IEEE 802.16e wireless standard
  53. Efficient rectifier design for wearable healthcare applications
  54. A Dual-Material Gate Junctionless Transistor With High-$k$ Spacer for Enhanced Analog Performance
  55. Design and Analysis of Spiral Inductors
  56. Choice of insulation materials and its effect on the performance of square microhotplate
  57. Analytical Modeling of Square Microhotplate for Gas Sensing Application
  58. A low noise preamplifier and switched capacitor filter for heart-rate detection
  59. Double-gate junctionless transistor for low power digital applications
  60. System level hardware testing of a high speed MAP decoder implemented on FPGA
  61. Performance and throughput analysis of turbo decoder for the physical layer of digital-video-broadcasting-satellite-services-to-handhelds standard
  62. A novel state metric normalization technique for high-throughput maximum-a-posteriori-probability decoder
  63. Distributed Arithmetic based Split-Radix FFT
  64. Effect of membrane to heater ratio on the performance of square microhotplate
  65. A strategy to enhance the output voltage of a charge pump circuit suitable for energy harvesting
  66. Double-Gate Junctionless Transistor for Analog Applications
  67. A Dual Material Double-Layer Gate Stack Junctionless Transistor for Enhanced Analog Performance
  68. An Ultra-Wideband Baseband Transmitter Design for Wireless Body Area Network
  69. Blind Navigation Assistance for Visually Impaired based on Local Depth Hypothesis from a Single Image
  70. Design and Implementation of a High Speed MAP Decoder Architecture for Turbo Decoding
  71. FEM Simulation Study on Mass Loading Sensitivity of High Aspect Ratio Nano-Pillar Sensing Medium in Saw Sensors
  72. Gain, NF and IIP3 Budgeting of LTE Receiver Front End
  73. High Sensitivity Microbridge for Molecular Sensing Applications
  74. Wafer scale thin-film transistors using different semiconducting purity nanotubes, dielectric materials and gate control
  75. Impact of high-k spacer on device performance of a junctionless transistor
  76. A 23.1µW 8 Bit 1.1 MS/s SAR ADC with counter based control logic
  77. Estimation of process-induced variations in double-gate junctionless transistor
  78. High-temperature effects on device performance of a junctionless transistor
  79. On chip high voltage single clock swing enhanced charge pump circuit in 0.18 µm technology
  80. Simulation study of power loss components in a microheater
  81. FPGA IMPLEMENTATION OF HIGH SPEED AND LOW POWER ARCHITECTURES FOR IMAGE SEGMENTATION USING SOBEL OPERATORS
  82. Low power 2.4 GHz RF transmitter for satellite subsystem using CORDIC based frequency translator
  83. Analog performance of bulk planar junctionless transistor (BPJLT)
  84. Design of data width requirement for fixed-point turbo decoders based on modified MAP algorithm
  85. Resonant Frequency Characteristics of a SAW Device Attached to Resonating Micropillars
  86. Comparison of DAC architectures of SAR ADCS
  87. Design and Implementation of a Linear Feedback Shift Register Interleaver for Turbo Decoding
  88. Multi-standard Σ - Δ Modulator for GSM/WCDMA Applications
  89. Simplified Model for FEM Simulation of SAW Delay Line Sensor
  90. Investigation on Resonance Effects of Closely Resonating Nano-Pillars Attached to SAW Resonator
  91. Fabrication of High Aspect Ratio SU-8 Microstructures on Piezoelectric Transducers
  92. Performance Comparison of Single- and Dual-Gate Carbon-Nanotube Thin-Film Field-Effect Transistors
  93. High-performance local back gate thin-film field-effect transistors using sorted carbon nanotubes on an amino-silane treated hafnium oxide surface
  94. FPGA implementation of image enhancement algorithms
  95. Hardware implementation of Max-Log-MAP algorithm based on MacLaurin series for turbo decoder
  96. HUMIDITY SENSOR USING NIPAAm NANOGEL AS SENSING MEDIUM IN SAW DEVICES
  97. Low power Viterbi Decoder by modified ACSU architecture and clock gating method
  98. Mass Loading in Coupled Resonators Consisting of SU-8 Micropillars Fabricated Over SAW Devices
  99. Design of QRS Detection and Heart Rate Estimation System on FPGA
  100. Fabrication and characterisation of high-performance and high-current back-gate thin-film field-effect transistors using sorted single-walled carbon nanotubes
  101. Fabrication of Carbon Nanotube Field Effect Transistor
  102. Geometry optimization of a MEMS-based energy harvesting device
  103. Performance Comparison of Interdigitated Thin-Film Field-Effect Transistors Using Different Purity Semiconducting Carbon Nanotubes
  104. Performance Comparison of Thin-Film Transistors Fabricated Using Different Purity Semiconducting Nanotubes
  105. Finite Element Method Simulation of a Surface Acoustic Wave Hydrogen Sensor with Palladium Nano-Pillars as Sensing Medium
  106. Mass Loading Effect of High Aspect Ratio Structures Grown Over Surface Acoustic Wave Resonators
  107. An Area-Throughput Efficient FPGA Implementation of the Block Cipher AES Algorithm
  108. Process Variations and Noise Analysis on a Miller Capacitance Tuned 1.8_2.4-GHz Dual-Band Low Noise Amplifier
  109. A low power inductive-coupled transceiver for inter-chip communication
  110. Power feeding and digital block design of multi-standard passive RFID tag
  111. A threshold inverter quantization based folding and interpolation ADC in 0.18 μm CMOS
  112. Design of multilevel pyramidically wound symmetric inductor for CMOS RFIC’s
  113. Impact of Bias Voltage on Magnetic Inductance of Carbon Nanotube Interconnects
  114. CMOS capacitive pressure sensor design and integration with RFID tag for biomedical applications
  115. Ultra wideband AGC and VGA designs for software radio applications
  116. A 1.6/1.8/2.1/2.4-GHz Multiband CMOS Low Noise Amplifier
  117. An improved ROM architecture for bubble error suppression in high speed flash ADCs
  118. A 1.8/2.4-ghz dualband cmos low noise amplifier using miller capacitance tuning
  119. Performance study of fixed value inductors and their optimization using electromagnetic simulator
  120. Quality factor enhancement of CMOS inductor with pyramidal winding of metal turns
  121. Efficient optimization of integrated spiral inductor with bounding of layout design parameters
  122. Systematic Analysis, Design and Optimization of On-Chip Spiral Inductor for Si based RFIC's
  123. A model to study the effect of selective anodic oxidation on ultrathin gate oxides
  124. Optimized dual temperature pulsed laser deposition of TiO2 to realize MTOS (metal-TiO2–SiO2–Si) capacitors with ultrathin gate dielectric
  125. Effect of oxygen pressure and laser fluence during pulsed laser deposition of TiO2 on MTOS (Metal–TiO2–SiO2–Si) capacitor characteristics
  126. Laser induced oxidation for growth of ultrathin gate oxide
  127. Improvement in electrical characteristics of ultrathin thermally grown SiO2 by selective anodic oxidation
  128. Pulsed laser deposition of TiO2 for MOS gate dielectric