What is it about?
The experimental and theoretic examination of conventional manufacturing procedures continue to be a topic of modern research. It is assisted, to a great extent, by the spread and the possibility of the application of high level software and more accurate measuring equipment. The research results obtained by the use of new equipment can open new ways for further development of conventional manufacturing procedures and their more intensive, more productive application.
Featured Image
Why is it important?
In this paper, an experimental method is used for examination of the surface features (e.g. flatness, 2D and 3D surface roughness parameters) of face milled aluminium parts. The aim of experiments was to determine the effect of change of the technological parameters (feed rate and cutting speed) on flatness and surface roughness features in of face milling of aluminium parts.
Perspectives
This paper deals with an experimental analysis of milling of aluminium workpieces. 2D roughness profiles and average values of 2D and 3D surface roughness parameters were introduced in 5 planes parallel to feed direction. We intend to examine of the use of other sape and type of inserts.
Dr. Gyula Varga
University of Miskolc
Read the Original
This page is a summary of: Effects of Technological Parameters on Surface Characteristics in Face Milling, Solid State Phenomena, August 2017, Trans Tech Publications,
DOI: 10.4028/www.scientific.net/ssp.261.285.
You can read the full text:
Contributors
The following have contributed to this page
