What is it about?

A simple but effective method for estimating the spring constant of commercially available atomic force microscope (AFM) cantilevers is presented, based on estimating the cantilever thickness from knowledge of its length, width, resonant frequency and the presence or absence of an added mass, such as a colloid probe at the cantilever apex, or a thin film of deposited material. The spring constant of the cantilever can then be estimated using standard equations for cantilever beams. The results are compared to spring constant calibration measurements performed using reference cantilevers. Additionally, the effect of the deposition of Cr and Ti thin films onto rectangular Si cantilevers is investigated.

Featured Image

Read the Original

This page is a summary of: On the calibration of rectangular atomic force microscope cantilevers modified by particle attachment and lamination, Measurement Science and Technology, October 2010, Institute of Physics Publishing,
DOI: 10.1088/0957-0233/21/11/115106.
You can read the full text:

Read

Contributors

The following have contributed to this page