What is it about?

In this study, a novel HTL-free PSC with the structure of FTO/TiO2/CH3NH3SnI3/Ni/glass has been designed and evaluated using the SCAPS-1D simulation tool. The numerical simulation is conducted to understand the performance of the proposed PSC by changing thickness, doping concentration, defect density, operating temperature, and series and shunt resistances. It is revealed from the simulation results that excellent photovoltaic performance can be achieved with the proposed HTL-free PSC structure. Furthermore, it is found through investigation that the output performance of the proposed device structure can be enhanced by utilizing favorable back contact materials with a high work function.

Featured Image

Why is it important?

The main goal of the ETL and the HTL is to transport electrons and holes generated by the light intensity inside the perovskite layer from the absorber to the front and back metallic contacts as well as to prevent the flow of electrons or holes from the absorber to the back or front contact. However, it is still a challenge to fabricate defect-free multi-layered PV devices. Moreover, the interface defects at the ETL or the HTL/perovskite promote carrier recombination and degrade the stability of the overall solar cell architecture. To overcome the challenges, in this work, a new concept of HTL-free solar device configuration has been introduced to the PV community, which would reduce the fabrication cost and interface defects without affecting cell performance.

Perspectives

Photovoltaic parameters including Voc of 0.98 V, Jsc of 31.93 mA/cm2, an FF of 84.34%, and an efficiency of 26.33% are obtained for the optimized 1.0 μm-thick CH3NH3SnI3 absorber layer. Therefore, this simulation study opens a new direction for a more simple, low-cost, highly efficient, and more stable HTL-free CH3NH3SnI3-based PSC.

Dr. Sheikh Rashel Al Ahmed
Pabna University of Science and Technology

Read the Original

This page is a summary of: Numerical study of high performance HTL-free CH3NH3SnI3-based perovskite solar cell by SCAPS-1D, AIP Advances, June 2021, American Institute of Physics,
DOI: 10.1063/5.0049646.
You can read the full text:

Read

Contributors

The following have contributed to this page