All Stories

  1. Observation of Tribological Fatigue Fracture on PEEK Shaft with Artificial Defect under One-Point Rolling Contact by Using 2.5D Layer Method
  2. Failure Observation of 3D-Printed Thrust Bearing Specimens with Inner Defects in Water Conditions
  3. Influence of Furnace-Induction Heating on Hardness Distribution and Retained Austenite in JIS SUJ2 Bearing Steel
  4. Rolling Contact Fatigue Life of 13Cr-2Ni-2Mo Stainless Steels which are Surface Treated by Induction Heating (IH) and Wide Peening Cleaning (WPC)
  5. Failure Observation of 3D-Printed Thrust Bearing Specimens at Cross Section Observations in Dry Conditions
  6. Observation of Fracture Surface of Induction-Heated JIS SUJ2 Bearing Steel under Rotating Bending Fatigue
  7. Observation of Furnace-Induction Quenched Microstructure in High Carbon High Chromium Steel
  8. Fatigue of Low Carbon Alloy Steel (JIS S45C) and a New Method of Fracture Surface Analysis
  9. Distribution of Aspect Ratio of Fatigue Crack at Notch Root Depending on Crack Initiation Point of Annealed Steel, JIS S45C
  10. Observation of fracture behavior of 3-D printed specimens under rolling contact fatigue in water
  11. Effect of Groove Geometry on Rolling Contact Fatigue of PEEK Thrust Bearings in Water
  12. Observation of Fatigue Fracture on PEEK Shaft against Alumina Bearing’s Ball under One-Point Rolling Contact
  13. Evaluation of Tribological Thermal Failure on PEEK-PTFE Hybrid Alumina Ball Bearings
  14. Observation of Cracks of PEEK Polymer Thrust Bearings under Rolling Contact Fatigue in Water
  15. Backlash Evaluation of Hybrid UHMWPE-PEEK Bushes in a Small Robot Joint System
  16. Effect of New Pocket Design on the Failure of Thrust UHMWPE Bearings in Dry Condition
  17. Rolling Contact Fatigue Observation of Radial PPS Bearings under Dry Condition
  18. Observation of Retained Austenite Amount of Repeatedly Induction Heated SUJ2 Bearing Steels
  19. Effect of Repeated Quenching on Rolling Contact Fatigue Properties of JIS SUJ2 Bearing Steel
  20. Relationship between Solid Lubricant Layer and Friction Coefficient of PPS Races-PTFE Retainer Hybrid Thrust Bearings under Dry Condition
  21. Application of the Betti Number to Prior Austenite Grain Size Analysis of Repeatedly Quenched Steel Based on the Homology Method
  22. Relation between the Betti Number of Fatigue Fracture Surfaces and Stress Intensity Factors of Low Carbon Steel (JIS, S45C)
  23. The Betti Number of Prior Austenite Structure of Repeated Quenching Bearing Steels (JIS, SUJ2)