All Stories

  1. Simple control strategy for a PV-battery system
  2. Hybrid Battery-Supercapacitor System for full electric Forklifts
  3. Economic viability for residential battery storage systems in grid-connected PV plants
  4. Lithium Ion Battery Models and Parameter Identification Techniques
  5. A linear programming approach to distribution Power Flow
  6. A novel current dependent lithium ion capacitor model: Analysis and experimental driving cycle test validation
  7. Power hardware in the loop simulator of photovoltaic plant for smart grid interation analysis
  8. Efficiency Assessment of Modular Multilevel Converters for Battery Electric Vehicles
  9. A lithium-ion capacitor model working on a wide temperature range
  10. Mismatch Based Diagnosis of PV Fields Relying on Monitored String Currents
  11. Harmonics and Interharmonics Compensation With Active Front-End Converters Based Only on Local Voltage Measurements
  12. A simple battery model for EV range prediction: Theory and experimental validation
  13. Characterization and Monitoring of a Self-Constructible Photovoltaic-Based Refrigerator
  14. Lithium-ion battery: A simplified modeling procedure and system simulation
  15. Control strategy of virtual synchronous generator based on virtual impedance and band-pass damping
  16. Low frequency operation of Modular Multilevel Converters with embedded battery cells for traction drives
  17. Overview of Lithium-ion Capacitor Applications Based on Experimental Performances
  18. A smart PV inverter controller with PMU capability
  19. Correct sizing of a storage unit for a residential PV plant
  20. Evaluation of voltages and currents in an IPT system through Kalman Filter
  21. Current balancing of cascaded H-bridge converters for PV systems with partial shading
  22. A methodology for a correct sizing of electrochemical storage devices
  23. Battery lifetime for different driving cycles of EVs
  24. DC Bus Stabilization of Li-Ion Battery Based Energy Storage for a Hydrogen/Solar Power Plant for Autonomous Network Applications
  25. Analysis of mathematical modeling of PV module with MPPT algorithm
  26. Alleviating power quality issues when integrating PV into built areas: Design and control of DC microgrids
  27. Design of a converter for photovoltaic panels testing
  28. Storage system control for correct operation of fault protections of single phase load in grids dominated by inverters
  29. Feasibility study of a solar photovoltaic adaptable refrigeration kit for remote areas in developing countries
  30. Fault protection analysis in low voltage DC microgrids with PV generators
  31. Optimized Adaptive Perturb and Observe Maximum Power Point Tracking Control for Photovoltaic Generation
  32. Electric loads characterization in an aircraft carrier with ring-bus distribution system
  33. Analysis, Design and Experimental Validation of Modified Simple Soft Switching DC-DC Boost Converter
  34. Analysis of Ageing Effect on Li-Polymer Batteries
  35. Nonlinear intelligent DC grid stabilization for fuel cell vehicle applications with a supercapacitor storage device
  36. DC bus stabilization of Li-Ion battery based energy storage for hydrogen/solar power plant for autonomous network applications
  37. Modeling and Parameter Identification of Lithium-Ion Capacitor Modules
  38. Comparison of accuracy of different LiFePO4 battery circuital models
  39. Differential flatness control approach for fuel cell/solar cell power plant with Li-ion battery storage device for grid-independent applications
  40. A nonlinear control algorithm of Li-ion battery substation for DC distributed system
  41. Innovative hybrid-eco bus: Control strategies for reducing fuel consumption
  42. A star-configured cascade H-bridge converter for building integrated photovoltaics
  43. DC Islands in AC Smart Grids
  44. Harmonic compensation with active front-end converters based only on grid voltage measurements
  45. Naval application of storage devices for loads protection in micro-grids dominated by solid state converters
  46. Ground fault analysis of low voltage DC micro-grids with active front-end converter
  47. Battery charging for electric vehicles with modular multilevel traction drives
  48. A novel circuital model for power electronic transformer: sizing and simulation
  49. Power and balancing control considerations on modular multilevel converters for battery electric vehicles
  50. Zero voltage switching configuration of a dual inductor current fed DC/DC converter
  51. Energy recovery and efficiency optimisation in a wood cutting machines
  52. Technical and economical evaluation of storage systems in naval applications
  53. Numerical and experimental validation of a LiFePO4 battery model at steady state and transient operations
  54. A novel PV-modular multilevel converter for building integrated photovoltaics
  55. New Full-Frequency-Range Supercapacitor Model With Easy Identification Procedure
  56. Storage systems for transportation, land handling and naval applications
  57. A modular converter with embedded battery cell balancing for electric vehicles
  58. High power quality level DC distribution system for woodworking plants
  59. A novel thyristor rectifier for series connection of wind turbines
  60. A new advanced method for assessment of waveform distortions caused by adjustable speed drives
  61. An analytical model of the induction machine for the development of diagnostic techniques
  62. Management of different energy storage devices using a losses minimization algorithm
  63. A control strategy for optimizing the power flows supplied by two different storage units
  64. A novel control of Dual-Excited Synchronous machines for variable-speed wind turbines
  65. Analysis of a structural failure mode arising in cage rotors of induction machines
  66. A vehicle with very low fuel consumption: Realization, analysis and optimization
  67. Simulations and field test results for potential applications of LV DC distribution network to reduce flicker effect
  68. A control algorithm of power converters in smart-grids for providing uninterruptible ancillary services
  69. Digital synchronous current control of Power Electronic Building Block in modular converters
  70. Rotor fault detection in field oriented controlled induction machines
  71. Adaptive perturb and observe algorithm for photovoltaic maximum power point tracking
  72. Experimental Performance of MPPT Algorithm for Photovoltaic Sources Subject to Inhomogeneous Insolation
  73. Sizing of photovoltaic sources and storage devices for stand-alone power plants
  74. Use of supercapacitors for energy saving in overhead travelling crane drives
  75. Technical and economic study of two repowered wind farms in Bustelo and San Xoán, 24.7 MW and 15.84 MW respectively
  76. Optimized design of a back-to-back rotor-side converter for doubly fed induction generator equipped Wind turbines
  77. Hybrid PV-CHP distributed system: Design aspects and realization
  78. A Dual Inductor Current fed dc/dc converter with ZVS active clamping, for fuel cell based plant
  79. Torsional eigenfrequency identification of squirrel cage rotors of induction motors
  80. An active filter used for harmonic compensation and power factor correction: A control technique
  81. A High Resolution Method for On Line Diagnosis of Induction Motors Faults
  82. Hybrid Electrochemical Power Sources for Onboard Applications
  83. A simple configuration and control system for grid connected synchronous generators
  84. High Efficiency Wind Generators with Variable Speed Dual-Excited Synchronous Machines
  85. A Control Technique for Doubly Fed Induction Generators to Solve Flicker Problems in Wind Power Generation
  86. A simple and efficacious control system for stand alone generation plants equipped with induction machines
  87. Torque fluctuation and critical clearing time in wind power generation by induction machines
  88. A filtering technique to solve flicker problems due to use of induction machines in wind power generation
  89. Study of saturation phenomena on asynchronous generators used in wind farms
  90. Generator operations of asynchronous induction machines connected to ac or dc active/passive electrical networks
  91. Electrical networks fed by fuel-cells for uninterruptible electrical supply
  92. Electrical Drives with Fuel Cells for Road Vehicles
  93. Supercapacitor flywheel for high power electrochemical sources
  94. State of charge monitoring for road vehicle batteries
  95. Torsional stress analysis ofsquirrel cage windings of asynchronous motors
  96. A ZVS current fed DC/DC converter oriented for applications fuel-cell-based
  97. A control strategy of induction machine to be used as generator in cogeneration plants in stand alone operations
  98. Voltage regulation on grid fed by fuel cell and electrochemical capacitor sources
  99. Approaches to analytical analysis of active filter behaviour
  100. An innovative algorithm for the velocity estimation both during dynamics and at steady state
  101. Experimental validation of a velocity estimation algorithm for speed control of electrical drives
  102. An optimised algorithm for velocity estimation method for motor drives
  103. Experimental evaluation of charge laws for road vehicle batteries