All Stories

  1. Ballistic response of 12.7 mm armour piercing projectile against perforated armour developed from structural steel

    Article • Proceedings of the Institution of Mechanical Engineers Part L Journal of Materials Design and Applications, October 2018, SAGE Publications

    Dr Aamir Mubashar

  2. Numerical and experimental investigation of Johnson–Cook material models for aluminum (Al 6061-T6) alloy using orthogonal machining approach

    Article • Advances in Mechanical Engineering, September 2018, SAGE Publications

    Dr Aamir Mubashar

  3. Effect of liner material and explosive type on penetration effectiveness of shaped charge

    Article • Proceedings of the Institution of Mechanical Engineers Part L Journal of Materials Design and Applications, January 2018, SAGE Publications

    Dr Aamir Mubashar

  4. A numerical study of the effect of ply-layup on the strength and stiffness of a composite T-joint under three point bending

    Article • Journal of Adhesion Science and Technology, January 2017, Taylor & Francis

    Dr Aamir Mubashar

  5. A numerical investigation and experimental validation on chip morphology of Aluminum Alloy 6061 during orthogonal machining

    Article • April 2016, Institute of Electrical & Electronics Engineers (IEEE)

    Dr Aamir Mubashar

  6. Analysis of weld characteristics of micro-plasma arc welding and tungsten inert gas welding of thin stainless steel (304L) sheet

    Article • Proceedings of the Institution of Mechanical Engineers Part L Journal of Materials Design and Applications, June 2015, SAGE Publications

    Dr Aamir Mubashar

  7. Improvement in the Mechanical Properties of High Temperature Shape Memory Alloy (Ti50Ni25Pd25) by Copper Addition

    Article • Advances in Materials Science and Engineering, January 2015, Hindawi Publishing Corporation

    Dr Aamir Mubashar

  8. A Numerical Investigation of Effects of Cutting Velocity and Feed Rate on Residual Stresses in Aluminum Alloy Al-6061

    Article • International Journal of Materials Mechanics and Manufacturing, January 2015, EJournal Publishing

    Dr Aamir Mubashar

  9. Modelling Damage and Failure in Adhesive Joints Using A Combined XFEM-Cohesive Element Methodology

    Article • The Journal of Adhesion, April 2014, Taylor & Francis

    Dr Aamir Mubashar

  10. Strength prediction of adhesive joints after cyclic moisture conditioning using a cohesive zone model

    Article • Engineering Fracture Mechanics, November 2011, Elsevier

    Dr Aamir Mubashar

  11. A Method of Predicting the Stresses in Adhesive Joints after Cyclic Moisture Conditioning

    Article • The Journal of Adhesion, September 2011, Taylor & Francis

    Dr Aamir Mubashar

  12. Numerical Approach: Finite Element Analysis

    Article • January 2011, Springer Science + Business Media

    Dr Aamir Mubashar

  13. Moisture absorption–desorption effects in adhesive joints

    Article • International Journal of Adhesion and Adhesives, December 2009, Elsevier

    Dr Aamir Mubashar

  14. Modelling Cyclic Moisture Uptake in an Epoxy Adhesive

    Article • The Journal of Adhesion, September 2009, Taylor & Francis

    Dr Aamir Mubashar

  15. White layer formation and tool wear in high speed milling of 57HRc tool steel using coated and uncoated tools

    Article • International Journal of Agile Systems and Management, January 2007, Inderscience Publishers

    Dr Aamir Mubashar