All Stories

  1. Evaluation of Relationship between Cutting Parameters and Torque in Hole Making of Titanium Alloy

    Article • Solid State Phenomena, August 2017, Trans Tech Publications

    professor Ildikó Maňková

  2. Effect of Honing Parameters on Generated Surface Quality of Cylinder Liner within Automotive Engine Production

    Article • Solid State Phenomena, August 2017, Trans Tech Publications

    professor Ildikó Maňková

  3. Types of Tool Wear of AlTiN Coated Cutting Insert after Machining of Weld Overlay

    Article • Solid State Phenomena, August 2017, Trans Tech Publications

    professor Ildikó Maňková

  4. Influence of Cutting Parameters and Tool Geometry on Thrust Force Behavior in Drilling Ti6Al4V

    Article • Materials Science Forum, August 2016, Trans Tech Publications

    professor Ildikó Maňková

  5. Tool Wear and Surface Roughness Evolution in Hole Making Process of Inconel 718

    Article • Materials Science Forum, August 2016, Trans Tech Publications

    professor Ildikó Maňková

  6. Comparison of Milling Strategies when Machining Freeform Surfaces

    Article • Materials Science Forum, August 2016, Trans Tech Publications

    professor Ildikó Maňková

  7. Sampling Based Assessment of the Free-Form Milling Strategies

    Article • Key Engineering Materials, February 2016, Trans Tech Publications

    professor Ildikó Maňková

  8. Modelling and Analysis of Relationship between Cutting Parameters Surface Roughness and Cutting Forces Using Response Surface Methodology when Hard Turning with Coated Ceramic Inserts

    Article • Key Engineering Materials, February 2016, Trans Tech Publications

    professor Ildikó Maňková