All Stories

  1. Effect of Selected Friction Stir Welding Parameters on Mechanical Properties of Joints

    Article • DELETED, December 2019, De Gruyter

    dr hab. inż. Paweł PK Kossakowski

  2. Mechanical Properties of Laminated Veneer Lumber Beams Strengthened with CFRP Sheets

    Article • DELETED, June 2019, De Gruyter

    dr hab. inż. Paweł PK Kossakowski

  3. Failure of the overhead crane runway

    Article • MATEC Web of Conferences, January 2019, EDP Sciences

    dr hab. inż. Paweł PK Kossakowski

  4. Estimation of the Modulus Fir Wood Reinforced With PBO Fiber Mesh

    Article • DELETED, December 2018, De Gruyter

    dr hab. inż. Paweł PK Kossakowski

  5. Analysis of the Void Volume Fraction for S235JR Steel at Failure for Low Initial Stress Triaxiality

    Article • DELETED, May 2018, De Gruyter

    dr hab. inż. Paweł PK Kossakowski

  6. A Case Study of Pre-Service Cracks in the Concrete Decks of a Two-Level Basement Car Park

    Article • DELETED, January 2017, De Gruyter

    dr hab. inż. Paweł PK Kossakowski

  7. Experimental determination of the void volume fraction for S235JR steel at failure in the range of high stress triaxialities

    Article • Archives of Metallurgy and Materials, January 2017, De Gruyter

    dr hab. inż. Paweł PK Kossakowski

  8. Failure of Steel Bridges due to Constraint Induced Fracture

    Article • Solid State Phenomena, April 2016, Trans Tech Publications

    dr hab. inż. Paweł PK Kossakowski

  9. The Influence of Microstructural Defects on the Stress State of S235JR Steel under Plastic Deformation

    Article • Solid State Phenomena, April 2016, Trans Tech Publications

    dr hab. inż. Paweł PK Kossakowski

  10. An Analysis of the Tvergaard Parameters at Low Initial Stress Triaxiality for S235JR Steel

    Article • Polish Maritime Research, January 2015, De Gruyter

    dr hab. inż. Paweł PK Kossakowski

  11. Stress Modified Critical Strain criterion for S235JR steel at low initial stress triaxiality

    Article • Journal of Theoretical and Applied Mechanics, October 2014, Polish Society of Theoretical and Applied Mechanics

    dr hab. inż. Paweł PK Kossakowski

  12. Effect of Critical Void Volume Fraction fF on Results of Ductile Fracture Simulation for S235JR Steel under Multi-Axial Stress States

    Article • Key Engineering Materials, January 2014, Trans Tech Publications

    dr hab. inż. Paweł PK Kossakowski

  13. Comparative Analysis of Measured and Predicted Shrinkage Strain in Concrete

    Article • Advances in Materials Science, January 2014, De Gruyter

    dr hab. inż. Paweł PK Kossakowski

  14. Fatigue strength of an over one hundred year old railway bridge

    Article • The Baltic Journal of Road and Bridge Engineering, September 2013, Vilnius Gediminas Technical University

    dr hab. inż. Paweł PK Kossakowski

  15. ASSESSMENT OF MATERIAL BEHAVIOUR AND STRUCTURAL INTEGRITY OF ENGINEERING STRUCTURES BASED ON R6 PROCEDURE

    Article • Advances in Materials Science, January 2013, De Gruyter

    dr hab. inż. Paweł PK Kossakowski

  16. The analysis of influence of Tvergaard's parameters on S235JR steel response in high stress triaxiality

    Article • Advances in Materials Science, January 2012, De Gruyter

    dr hab. inż. Paweł PK Kossakowski

  17. Effect of Initial Porosity on Material Response Under Multi-Axial Stress State for S235JR Steel

    Article • DELETED, January 2012, De Gruyter

    dr hab. inż. Paweł PK Kossakowski

  18. Influence of Initial Porosity on Strength Properties of S235JR Steel at Low Stress Triaxiality

    Article • DELETED, January 2012, De Gruyter

    dr hab. inż. Paweł PK Kossakowski