All Stories

  1. Steady-state interfacial gravity waves with one-dimensional class-IV triad resonance
  2. On the steady-state exactly resonant, nearly resonant, and non-resonant waves and their relationships
  3. Dynamic modelling and analysis of an adsorption-based power and cooling cogeneration system
  4. Enhancing the Thermo-Mechanical Property of Polymer by Weaving and Mixing High Length–Diameter Ratio Filler
  5. Experimental investigation of loop heat pipe with a large squared evaporator for multi-heat sources cooling
  6. Alternative thermal regenerative osmotic heat engines for low-grade heat harvesting
  7. Analysis of temperature and concentration polarizations for performance improvement in direct contact membrane distillation
  8. Design and optimization of bio-inspired wave-like channel for a PEM fuel cell applying genetic algorithm
  9. An irreversible Stirling cycle with temperature difference both in non-isothermal and isochoric processes
  10. Effect of different charge ratios on transient performance of a flat type of the LHP with a shared compensation chamber
  11. Structure optimization and exergy analysis of a two-stage TEC with two different connections
  12. Comparison of Thermomechanical Properties for Weaved Polyethylene and Its Nanocomposite Based on the CNT Junction by Molecular Dynamics Simulation
  13. Turbulent heat transfer optimization for solar air heater with variation method based on exergy destruction minimization principle
  14. Effects of rib arrangements on the performance of a parabolic trough receiver with ribbed absorber tube
  15. Finite time thermodynamic analysis of a solar duplex Stirling refrigerator
  16. Clean and stable utilization of solar energy by integrating dish solar Stirling engine and salinity gradient technology
  17. Dynamic performance analysis and optimization of dish solar Stirling engine based on a modified theoretical model
  18. Experimental investigation of a miniature loop heat pipe with eccentric evaporator for cooling electronics
  19. Experimental and numerical investigation on shell-side performance of a double shell-pass rod baffle heat exchanger
  20. Bioinspired fractal nanochannels for high-performance salinity gradient energy conversion
  21. Lattice Boltzmann simulation of nucleate boiling in micro-pillar structured surface
  22. Effect of longitudinal vortex generator on the heat transfer enhancement of a circular tube
  23. Numerical Study on Heat Transfer Performance in Packed Bed
  24. Numerical Simulation and Optimization of Waste Heat Recovery in a Sinter Vertical Tank
  25. Geometric Optimization of Two-stage Thermoelectric Generator Using Genetic Algorithms and Thermodynamic Analysis
  26. Numerical study on flow characteristics and heat transfer enhancement of oscillatory flow in a spirally corrugated tube
  27. Heat transfer enhancement for laminar flow in a tube using bidirectional conical strip inserts
  28. Optimal shape design of a minichannel heat sink applying multi-objective optimization algorithm and three-dimensional numerical method
  29. Study of heat transfer in oscillatory flow for a Stirling engine heating tube inserted with spiral spring
  30. Study on thermal conductivities of Si thin films and porous Si structures based on a modified lattice Boltzmann method
  31. Temperature regulated reverse electrodialysis in charged nanopores
  32. Performance investigation of PEMFC with rectangle blockages in Gas Channel based on field synergy principle
  33. Self-Removal of Multiple and Multisize Coalescing Nanodroplets on Nanostructured Surfaces
  34. Numerical Simulation of Water Transport in a Proton Exchange Membrane Flow Cell Flow Channel
  35. High Thermal Conductivity of Flake Graphite Reinforced Polyethylene Composites Fabricated by the Powder Mixing Method and the Melt-Extruding Process
  36. Nanodroplets Impact on Rough Surfaces: A Simulation and Theoretical Study
  37. A consistent SIMPLE algorithm with extra explicit prediction — SIMPLEPC
  38. A continuous concentration gradient flow electrical energy storage system based on reverse osmosis and pressure retarded osmosis
  39. An experimental and numerical study on the laminar heat transfer and flow characteristics of a circular tube fitted with multiple conical strips inserts
  40. Performance analysis and multi-objective optimization of a Stirling engine based on MOPSOCD
  41. Coalescence-Induced Jumping of Nanodroplets on Textured Surfaces
  42. Finite amplitude steady-state wave groups with multiple near resonances in deep water
  43. Heat transfer and pressure drop characteristics of R134a flow boiling in the parallel/tandem microchannel heat sinks
  44. Multi-objective optimization of operating conditions and channel structure for a proton exchange membrane fuel cell
  45. On Steady-State Multiple Resonances for a Modified Bretherton Equation
  46. Impact of torsion and stretching on the thermal conductivity of polyethylene strands
  47. Experimental study of an ammonia loop heat pipe with a flat plate evaporator
  48. Multi-objective genetic optimization of the heat transfer for tube inserted with porous media
  49. Effects of rib arrangements on the flow pattern and heat transfer in an internally ribbed heat exchanger tube
  50. The application of exergy destruction minimization in convective heat transfer optimization
  51. Numerical study on heat transfer enhancement characteristics of tube inserted with centrally hollow narrow twisted tapes
  52. Experimental study on loop heat pipe with two-wick flat evaporator
  53. Effect of humidified water vapor on heat balance management in a proton exchange membrane fuel cell stack
  54. Numerical study and performance analyses of the mini-channel with discrete double-inclined ribs
  55. Experimental investigation of pump-assisted capillary phase change loop
  56. Experimental study of the loop heat pipe with a flat disk-shaped evaporator
  57. Performance optimization of minimally nonlinear irreversible heat engines and refrigerators under a trade-off figure of merit
  58. Operation characteristics of air-cooled proton exchange membrane fuel cell stacks under ambient pressure
  59. A Heat Transfer Optimization for Reducing Thermal and Flow Resistances
  60. Simulation of Multiphase Flow and Heat Transfer in Porous Media Using Lattice Boltzmann Method
  61. Numerical studies on heat transfer and friction factor characteristics of a tube fitted with helical screw-tape without core-rod inserts
  62. In situ measurement of temperature distribution in proton exchange membrane fuel cell I a hydrogen–air stack
  63. Evaluation of self-water-removal in a dead-ended proton exchange membrane fuel cell
  64. Water distribution and removal along the flow channel in proton exchange membrane fuel cells
  65. Operational characteristics of flat type loop heat pipe with biporous wick
  66. Numerical studies on heat transfer and flow characteristics for laminar flow in a tube with multiple regularly spaced twisted tapes
  67. Application of a multi-field synergy principle in the performance evaluation of convective heat transfer enhancement in a tube
  68. Enhancing convective heat transfer based on minimum power consumption principle
  69. Development of biporous wicks for flat-plate loop heat pipe
  70. Investigation of impact of different working fluids on the operational characteristics of miniature LHP with flat evaporator
  71. Experimental investigation of shell-and-tube heat exchanger with a new type of baffles
  72. Interface stability in a capillary loop undergoing phase changes in non-gravitational conditions
  73. Physical quantity synergy in the field of turbulent heat transfer and its analysis for heat transfer enhancement
  74. WITHDRAWN: Operational characteristics of loop heat pipe with flat evaporator
  75. Numerical Studies on Heat Transfer and Friction Factor Characteristics of a Tube Fitted With Helical Twisted Tape Without Core-Rod Inserts
  76. Operational characteristics of miniature loop heat pipe with flat evaporator
  77. Phase change driving mechanism and modeling for heat pipe with porous wick
  78. Physical quantity synergy in laminar flow field of convective heat transfer and analysis of heat transfer enhancement
  79. Flow mechanism and heat transfer enhancement in longitudinal-flow tube bundle of shell-and-tube heat exchanger
  80. Physical quantity synergy in laminar flow field and its application in heat transfer enhancement
  81. An Experimental Investigation of Miniature Loop Heat Pipe with Flat Evaporator
  82. Temperature Oscillation of mLHP with Flat Evaporator
  83. Study on Heat Transfer Perpormance for Developing Laminar Tube Flow Inserted with Ringy Porous
  84. Criterion for Local Thermal Equilibrium in Forced Convection Flow Through Porous Media
  85. Design and Experimental Research of a Flat-Plate Type CPL with a Porous Wick in the Condenser
  86. Numerical investigation for flow and heat transfer in longitudinal-flow tube bundle of shell-and-tube heat exchanger
  87. Experimental Investigation of New Flat-Plate-Type Capillary Pumped Loop
  88. Numerical Simulation of Two Phase Flow and Heat Transfer in CPL Condenser With Porous Wick
  89. Extraction of exposure modeling parameters of thick resist
  90. Experimental Investigation of Miniature Loop Heat Pipe with Flat Evaporator