All Stories

  1. Additive manufacturing of short fiber oxide ceramic matrix composite

    Article • International Journal of Applied Ceramic Technology, July 2024, Wiley

    Jonas Stiller

  2. Inductive Heating of Ceramic Matrix Composites (CMC) for High-Temperature Applications

    Article • Materials, May 2024, MDPI AG

    Jonas Stiller

  3. Integration of Carbon Nanotubes (CNT) in Oxide Ceramic Composites for Temperature Sensing Applications

    Article • September 2023, Institute of Electrical & Electronics Engineers (IEEE)

    Jonas Stiller

  4. Combining Pultrusion with Carbonization: Process Analysis and Material Properties of CFRP and C/C

    Article • Ceramics, February 2023, MDPI AG

    Jonas Stiller

  5. Thermoset IM‐LSI‐based C/C‐SiC: Influence of flow direction and weld lines on microstructure and mechanical properties

    Article • International Journal of Applied Ceramic Technology, December 2020, Wiley

    Jonas Stiller

  6. Properties of C/C‐SiC composites produced via transfer moulding and inner siliconization

    Article • International Journal of Applied Ceramic Technology, May 2020, Wiley

    Jonas Stiller

  7. Injection Moulding of Oxide Ceramic Matrix Composites: Comparing Two Feedstocks

    Article • Key Engineering Materials, June 2019, Trans Tech Publications

    Prof. Daisy Nestler, Jonas Stiller

  8. Influence of Initial Fibre Length and Content Used in the Injection Moulding of CFRP on the Properties of C/C and C/C-SiC Composites

    Article • Key Engineering Materials, June 2019, Trans Tech Publications

    Prof. Daisy Nestler, Jonas Stiller

  9. Getting longer fibers in ceramic matrix composites

    Article • Key Engineering Materials, June 2019, Trans Tech Publications

    Prof. Daisy Nestler, Jonas Stiller

  10. New large-scale production method for C/C-SiC ceramics: Investigating the influence of chopped and nonwoven CF

    Article • Ceramics International, May 2019, Elsevier

    Jonas Stiller

  11. Evaluation of the Technical-Economic Potential of Thermosetting Injection Moulding for Shaping of C/C-SiC-Ceramics

    Article • Procedia CIRP, January 2019, Elsevier

    Jonas Stiller

  12. Continuous, Free‐Formable Sandwich Design with 3D Fiber Reinforced Core for Increased Lightweight Level of Applications in Large‐Scale Production

    Article • Advanced Engineering Materials, July 2018, Wiley

    Jonas Stiller

  13. Material Selection and Process Configuration for Free-Form, Voluminous and Textile-Based Multi-Material-Design by the Example of a Bucket Seat

    Article • Key Engineering Materials, July 2017, Trans Tech Publications

    Prof. Daisy Nestler, Jonas Stiller

  14. Effect of Maleic Anhydride Modification on the Mechanical Properties of a Highly Filled Glass Fibre Reinforced, Low-Viscosity Polypropylene for Injection Moulding

    Article • Journal of Materials Science Research, February 2016, Canadian Center of Science and Education

    Jonas Stiller

  15. A quantitative comparison of the capabilities of in situ computed tomography and conventional computed tomography for damage analysis of composites

    Article • Composites Science and Technology, April 2015, Elsevier

    Jonas Stiller