All Stories

  1. Deep Learning-Based Detection of Carotid Artery Atheromas in Panoramic Radiographs
  2. Extended Soft-Switching Modulation for Isolated Single-Phase AC–DC Converter with Integrated Power Stage
  3. Nonlinear control technique for enhanced synchronization systems: Improving dynamics and noise rejection of phase-locked loops
  4. Non-Isolated High Step-Up DC-DC Interleaved Boost Converter Based on Coupled Inductors and Voltage Multiplier Cells
  5. Distributed Multi-Agent Energy Management for Microgrids in a Co-Simulation Framework
  6. Nonisolated High Step‐Up DC‐DC Ćuk Converter Based on Coupled Inductors
  7. Influence of low-voltage ride-through control techniques on the thermal behavior of power converters applied to wind energy conversion systems based on the doubly-fed induction generator
  8. Site suitability analysis for green hydrogen production using multi-criteria decision-making methods: A case study in the state of Ceará, Brazil
  9. Techno-economic analysis of green hydrogen generation from combined wind and photovoltaic systems based on hourly temporal correlation
  10. Family of Non-Isolated High Step-Up DC-DC Converters Based on The Three-State Switching Cell and Coupled Inductors
  11. Magnetic Integration Applied to an Isolated Single-Stage AC–DC Converter
  12. Accurate and Fast Convergence Technique for Enhanced Efficiency and Performance of Photovoltaic Systems
  13. Switched-Capacitor-Based Hybrid Resonant Bidirectional Buck–Boost Converter for Improving Energy Harvesting in Photovoltaic Systems
  14. Fault-Tolerant Control for Quadcopters Under Actuator and Sensor Faults
  15. Non-intrusive demand response management strategy to mitigate the impacts of residential electric vehicle charging on distribution systems
  16. Stability analysis and application of a synchronverter-based control approach to DFIG-based wind energy conversion systems
  17. Modelling, design and control of power electronic converters for smart grids and electric vehicle applications
  18. Reliability assessment applied in the design of an industrial substation in the context of Industry 4.0
  19. Generalized Pulse Width Modulation Switch Model for Converters Based on the Multistate Switching Cell in Discontinuous Conduction Mode
  20. Review, Properties, and Synthesis of Single-Switch Non-Isolated DC-DC Converters with a Wide Conversion Range
  21. Unified Small-Signal Model for DC–DC Converters Based on the Four-State Switching Cell in Discontinuous Conduction Mode
  22. Step-Up/Step-Down Switched Capacitor Direct AC–AC Converter
  23. Magnetic Integration in A Soft-Switching Three-Phase Isolated DC-DC Converter
  24. Novel Control Approach for Resonant Class-DE Inverters Applied in Wireless Power Transfer Systems
  25. Co-simulation platform for the assessment of transactive energy systems
  26. Unified small‐signal model for DC‐DC converters based on the three‐state switching cell operating in discontinuous conduction mode
  27. Modified Active-Clamped Current-Fed DC–DC Push–Pull Converter
  28. Distributed control based on the consensus algorithm for the efficient charging of electric vehicles
  29. Three‐phase bidirectional isolated LLC resonant DC‐DC converter for DC microgrid applications
  30. Novel Isolated Multiple-Input, Multiple-Output Multidirectional Converter for Modern Low-Voltage DC Power Distribution Architectures
  31. Smart Protection System for Microgrids Based on an Adaptive Algorithm
  32. Synchronverter-based frequency control technique applied in wind energy conversion systems based on the doubly-fed induction generator
  33. Adaptive fuzzy directional bat algorithm for the optimal coordination of protection systems based on directional overcurrent relays
  34. Family of Non-Isolated High Step-Up DC–DC Converters Based on the Multi-State Switching Cell
  35. Family of single‐phase high‐frequency isolated AC–AC converters
  36. Wheel Slip Control Applied to an Electric Tractor for Improving Tractive Efficiency and Reducing Energy Consumption
  37. Single-Phase Isolated AC-AC Converters Based on the Dual Active Bridge Converter
  38. Four-Port, Single-Stage, Multidirectional AC–AC Converter for Solid-State Transformer Applications
  39. Nonisolated high step‐up DC‐DC interleaved SEPIC converter based on voltage multiplier cells
  40. Thermal Analysis of Power Converters for DFIG-Based Wind Energy Conversion Systems during Voltage Sags
  41. Modified Artificial Potential Field for the Path Planning of Aircraft Swarms in Three-Dimensional Environments
  42. Single-Phase Isolated AC–AC Symmetrical Full-Bridge Converter
  43. Maximum power point tracking technique based on sweeping the characteristic curve of the photovoltaic module
  44. Magnetic Integration in High-Frequency-Isolated AC-AC Interleaved Converters
  45. Bidirectional Isolated Asymmetrical Multilevel Inverter
  46. Non‐isolated high step‐up DC–DC converter based on coupled inductors, diode‐capacitor networks, and voltage multiplier cells
  47. Novel differential power processing topology for the mitigation of mismatch in photovoltaic systems
  48. General Evaluation of Rectifier Arrangements for the Three-Phase DC/DC Converter
  49. Non‐isolated high step‐up / step‐down DC–DC quadratic Ćuk converter
  50. Non‐isolated high step‐up/step‐down quadratic converter for light‐emitting diode driving
  51. Switched Capacitor DC-DC Converters: A Survey on the Main Topologies, Design Characteristics, and Applications
  52. Non‐isolated single‐phase inverter based on an autotransformer for low‐power applications
  53. Plotting Characteristic Curves of Photovoltaic Modules: A Simple and Portable Approach
  54. Improved and accurate low‐frequency average modelling and control of a conventional power factor correction boost converter in continuous conduction mode
  55. In‐depth analysis of an RCD snubber applied to a DC‐DC boost converter
  56. Reduced-order modeling approach for wind energy conversion systems based on the doubly-fed induction generator
  57. Three-phase phase-locked loop algorithm and application to a static synchronous compensator
  58. An integrated design approach of LCL filters based on nonlinear inductors for grid-connected inverter applications
  59. Household induction cooking system based on a grid-connected photovoltaic system
  60. Efficient two-stage offline driver for extra-high-current COB LED applications
  61. Interleaved bidirectional DC–DC converter for electric vehicle applications based on multiple energy storage devices
  62. Nonisolated DC–DC Converters With Wide Conversion Range for High-Power Applications
  63. Bidirectional Three-Level Stacked Neutral-Point-Clamped Converter for Electric Vehicle Charging Stations
  64. A Phase-Locked Loop Algorithm for Single-Phase Systems With Inherent Disturbance Rejection
  65. Novel conception of an electric propulsion system for a 9-kW electric tractor suitable to family farming
  66. Experimental evaluation of active power factor correction techniques in a single‐phase AC‐DC boost converter
  67. Single‐switch, integrated DC–DC converter for high‐voltage step‐down applications
  68. Development of A Small-Signal Model for The DC-DC Buck Converter Based on The Three-State Switching Cell
  69. A Survey on Topologies Based on The Three-State and Multi-State Switching Cells
  70. Modeling and Experimental Validation of a Single-Phase Series Active Power Filter for Harmonic Voltage Reduction
  71. Analysis of a static model for DC microgrids based on droop and MPPT control
  72. A step-up/step-down direct current to direct current converter for high-power, high-current applications
  73. Three-Phase Grid-Connected WECS With Mechanical Power Control
  74. Assessment of the ideality factor on the performance of photovoltaic modules
  75. A 3SSC-Based Nonisolated DC-DC Boost-Type Converter with Balanced Output Voltage and Wide Voltage Conversion Range
  76. A DC-DC buck-boost converter based on the three-state switching cell
  77. Analysis of a high power COB led light source driven by offline double-stage PFC converter
  78. Comparative analysis of basic single-stage non-isolated AC-DC topologies employed as high-current COB LED drivers
  79. Current multilevel pfc buck rectifier applied to a high-power COB LED driver
  80. Detailed design procedure of a DC-DC buck-boost converter employing a passive snubber
  81. Portable and low cost photovoltaic curve tracer
  82. Practical design of a DC-DC buck converter using an RCD snubber
  83. Small-signal model validation of a SEPIC converter based on the three-state switching cell in CCM using the PWM switch model
  84. A soft switching ZCS–ZVS double two-switch forward converter
  85. Application of ADALINE-based ARX model to control the DC-link voltage in resonant inverters used in induction cookers
  86. Evaluation of IGBT modules in ASDs submitted to overvoltage
  87. Comparison among mathematical models of the photovoltaic cell for computer simulation purposes
  88. Influence of series and shunt resistances in the ideality factor of photovoltaic modules
  89. Modeling, Digital Control, and Implementation of a Three-Phase Four-Wire Power Converter Used as a Power Redistribution Device
  90. Analysis of the low-frequency output current ripple in a buck-based LED driver under distinct control techniques
  91. Analysis, design, and implementation of soft-switching cells applied to the single-phase full-bridge inverter
  92. Analysis and small-signal modeling of a nonisolated high voltage step-up dc-dc boost converter
  93. Application of the commutated power concept to the classical isolated dc-dc converters
  94. Comparison of control techniques used in power factor correction rectifiers
  95. High-voltage gain dc–dc boost converter with coupled inductors for photovoltaic systems
  96. Survey on non-isolated high-voltage step-up dc–dc topologies based on the boost converter
  97. Novel bidirectional DC–DC converters based on the three-state switching cell
  98. Analysis of high voltage step-up nonisolated DC–DC boost converters
  99. Low cost wind energy conversion system based on the discontinuous conduction mode three-phase semi-controlled rectifier
  100. Soft switching high-voltage gain dc–dc interleaved boost converter
  101. Comparative Study of Maximum Power Point Tracking Techniques for Photovoltaic Systems
  102. Comparative study of high power factor boost rectifiers in continuous conduction mode
  103. An extensive review of nonisolated DC-DC boost-based converters
  104. A Nonisolated DC–DC Boost Converter With High Voltage Gain and Balanced Output Voltage
  105. Comprehensive review of high power factor ac-dc boost converters for PFC applications
  106. DC–DC Nonisolated Boost Converter Based on the Three-State Switching Cell and Voltage Multiplier Cells
  107. DC-DC nonisolated boost converter with high voltage gain adequate for split-capacitor inverter applications
  108. Modelling of nonisolated high-voltage gain boost converters using the PWM switch model
  109. Comparative analysis between overlapping and non-overlapping operation modes for the PWM buck converter using the three-state switching cell
  110. A DC–DC Converter Based on the Three-State Switching Cell for High Current and Voltage Step-Down Applications
  111. ZVS bidirectional isolated three-phase DC-DC converter with dual phase-shift and variable duty cycle
  112. Novel Nonisolated High-Voltage Gain DC–DC Converters Based on 3SSC and VMC
  113. Power Factor Correction Boost Converter Based on the Three-State Switching Cell
  114. Piezoelectric actuators applied to neutralize mechanical vibrations
  115. Comparison of nonisolated dc-dc converters from the efficiency point of view
  116. Analysis, Design, and Experimentation of a Double Forward Converter With Soft Switching Characteristics for All Switches
  117. Two-stage single-phase grid-connected photovoltaic system with reduced complexity
  118. An efficient switch-mode power supply using an AC-DC interleaved boost converter and a DC-DC full-bridge topology
  119. Study, Design and Implementation of a High Efficiency AC-DC-AC SMPS with Soft Switching Characteristics
  120. Case Study: Hydroelectric Generation Employing the Water Distribution Network in Pato Branco, Brazil
  121. A Grid-Connected PV System based on the Buck Converter
  122. Two-Stage Isolated Switch-Mode Power Supply With High Efficiency and High Input Power Factor
  123. A review of single-phase PFC topologies based on the boost converter
  124. A high power factor rectifier associated with a ZCZVS PWM full-bridge inverter in a rectifier/inverter system
  125. A Passive Lossless Snubber Applied to the AC–DC Interleaved Boost Converter
  126. Non-isolated DC-DC converters with wide conversion range used to drive high-brightness LEDs
  127. A low cost single-phase grid-connected photovoltaic system with reduced complexity
  128. A switched-mode power supply using a boost-flyback converter and an interleaved soft-switching forward topology
  129. Proposal of a Soft-Switching Single-Phase Three-Level Rectifier
  130. Analysis and Evaluation of Residential Air Conditioners for Power System Studies
  131. On the Study of Losses in Cables and Transformers in Nonsinusoidal Conditions
  132. A High-Power-Factor Half-Bridge Doubler Boost Converter Without Commutation Losses
  133. A unity power factor single-phase three-level rectifier associated with a passive nondissipative snubber
  134. Proposal of a SMPS with AC output voltage employing a quadratic boost converter, a new topology of soft-switched two-switch forward converter and a new topology of PWM three-level half-bridge inverter
  135. A ZCZVT PWM three-level full-bridge McMurray inverter
  136. A switched-mode power supply employing a quadratic boost converter and a soft-switched two-switch forward converter
  137. A novel high power factor switched-mode power supply employing an interleaved boost-flyback converter and a ZCZVS PWM full-bridge McMurray inverter
  138. A new topology of three-level half bridge inverter
  139. A new topology of soft-switched two-gwd'itch forward converter and a new topology of PWM three-level half-bridge inverter
  140. Association of a ZCZVS PWM three-level full-bridge McMurray inverter and an auxiliary power supply
  141. A high power factor power supply employing a self-oscillating converter to supply control circuitry