All Stories

  1. Field polarity effects on single and dual-droplet transport and evaporation in electric fields
  2. Experimental Investigation of Heat Transfer Coefficients in a Plate Heat Exchange for an Organic Rankine Cycle
  3. Impact of rotor size and axial spacing on the aerodynamic performance and power generation of offshore floating dual-rotor wind turbines
  4. Numerical investigation of pulsed heating effects on MgH2 desorption kinetics and thermal efficiency in solid-state hydrogen storage
  5. Expansion refrigeration characteristics of a supersonic condensation and deposition chamber for the CO2 heat pump cycle
  6. Homogeneous nucleation and condensation characteristics of water vapor-hydrogen (H2O-H2) binary systems from molecular dynamics simulation
  7. Multi-domain analysis and optimisation for plate heat exchangers: Integrating theory, Experiment, and CFD-based approaches
  8. Performance analysis of centrifugal compressors in supercritical CO₂ Brayton cycles considering non-equilibrium condensation
  9. Investigation on formation, evolution, and performance impact of mixing layer in the zeotropic mixture ejector
  10. Comparative analysis of heat transfer enhancement using direct current and alternating current corona discharge in pin fin arrays
  11. The potential of machine learning to predict melting response time of phase change materials in triplex-tube latent thermal energy storage systems
  12. Multi-objective optimization of supersonic separator for gas removal and carbon capture using three-field two-phase flow model and non-dominated sorting Genetic Algorithm-II (NSGA-II)
  13. Modeling the impact of temperature-dependent thermal conductivity on hydrogen desorption from magnesium hydride
  14. Heat exchanger design and performance evaluation for a high-temperature heat pump system under different two-phase correlations: 4E analysis
  15. Effect of Twisted Tapes on Swirling Flow Dynamics in Gas–Solid Two-Phase Flows for Natural Gas Hydrate Transportation
  16. Two-Phase Swirling Flow and Gas Hydrate Particle Deposition Behavior in Bending Pipelines
  17. CFD-DEM investigation of vortex characteristics within the hydraulic jet pumps in the vertical hydraulic conveying process
  18. Evaluation of thermal performance of immersion flow boiling thermal management in large-scale battery packs with simplified model
  19. Asymmetrical morphological evolution and energy conversion of droplets impacting on the moving film
  20. The impacts of structural parameters on performance and energy loss of the supersonic separator: A sensitivity analysis
  21. Research on thermal runaway propagation of lithium-ion batteries based on cold plate cooling and flame-retardant materials
  22. Study on evolution law of non-equilibrium phase transition flow and performance improvement of steam ejector for MED-TVC desalination system
  23. Supersonic Separators for Sustainable Gas Purification
  24. Micropores formation and effects in the magnetization roasting of limonite ore
  25. New insights into coarse particle lifting performance of a hydraulic ejector with an ultra-large area ratio
  26. Morphology and heat transfer of a train of microdroplets impinging on the heated surface for spray cooling
  27. Evaluating and optimizing of steam ejector performance considering heterogeneous condensation using machine learning framework
  28. Numerical investigations on compressible thermal flows in high-speed water entry
  29. Exergy performance analysis of hydrogen recirculation ejectors exhibiting phase change behaviour in PEMFC applications
  30. Supersonic separation towards sustainable gas removal and carbon capture
  31. Effect of gas-solid flow parameters and fracture structure parameter on particle deposition characteristics in the mining-induced fracture
  32. Comparative study on the organic rankine cycle off-design performance under different zeotropic mixture flow boiling correlations
  33. Experimental investigation on droplet evolutions in co-flow around the bluff body
  34. Performance of supercritical carbon dioxide (sCO2) centrifugal compressors in the Brayton cycle considering non-equilibrium condensation and exergy efficiency
  35. Performance Evaluation of a Steam Ejector Considering Non-Equilibrium Condensation in Supersonic Flows
  36. Experimental study and chemical affinity model on the inhibition of CO2 gas hydrate formation
  37. A comparative study on design and performance evaluation of Organic Rankine Cycle (ORC) under different two-phase heat transfer correlations
  38. Performance evaluation of a solar photovoltaic-thermal (PV/T) air collector system
  39. Energy efficiency assessment of hydrogen recirculation ejectors for proton exchange membrane fuel cell (PEMFC) system
  40. Joule-Thomson effect and flow behavior for energy-efficient dehydration of high-pressure natural gas in supersonic separator
  41. Leaf-vein bionic fin configurations for enhanced thermal energy storage performance of phase change materials in smart heating and cooling systems
  42. Energy Extraction and Processing Science
  43. Solidification performance improvement of phase change materials for latent heat thermal energy storage using novel branch-structured fins and nanoparticles
  44. High-pressure supersonic carbon dioxide (CO2) separation benefiting carbon capture, utilisation and storage (CCUS) technology
  45. Power Output Optimisation via Arranging Gas Flow Channels for Low-Temperature Polymer Electrolyte Membrane Fuel Cell (PEMFC) for Hydrogen-Powered Vehicles
  46. Combination of genetic algorithm and CFD modelling to develop a new model for reliable prediction of normal shock wave in supersonic flows contributing to carbon capture
  47. Energy storage performance improvement of phase change materials-based triplex-tube heat exchanger (TTHX) using liquid–solid interface-informed fin configurations
  48. A modified Euler-Lagrange-Euler approach for modelling homogeneous and heterogeneous condensing droplets and films in supersonic flows
  49. Numerical analysis of propellers for electric boats using computational fluid dynamics modelling
  50. A potential strategy of carbon dioxide separation using supersonic flows
  51. Performance enhancement of phase change materials in triplex-tube latent heat energy storage system using novel fin configurations
  52. Optimum Efficiency of a Steam Ejector for Fire Suppression Based on the Variable Mixing Section Diameter
  53. Optimisation and Efficiency Improvement of Electric Vehicles Using Computational Fluid Dynamics Modelling
  54. Numerical simulation of supersonic condensation flows using Eulerian-Lagrangian and Eulerian wall film models
  55. A novel thermal management system for battery packs in hybrid electrical vehicles utilising waste heat recovery
  56. Unsteady non-equilibrium condensation flow of 3-D wet steam stage of steam turbine with roughness using sliding mesh method
  57. Improving the melting performance of phase change materials using novel fins and nanoparticles in tubular energy storage systems
  58. A visual mass transfer study in the ejector considering phase change for multi-effect distillation with thermal vapour compression (MED-TVC) desalination system
  59. Nanoparticles to Enhance Melting Performance of Phase Change Materials for Thermal Energy Storage
  60. Roadmap to hydrogen society of Tokyo: Locating priority of hydrogen facilities based on multiple big data fusion
  61. The droplets and film behaviors in supersonic separator by using three-field two-fluid model with heterogenous condensation
  62. Thermodynamics analysis of CO2 condensation in supersonic flows for the potential of clean offshore natural gas processing
  63. Effect of area ratio of the primary nozzle on steam ejector performance considering nonequilibrium condensations
  64. Modeling of self-excited oscillation of non-equilibrium condensation in transonic moist air flow
  65. A Novel Dehumidification Strategy to Reduce Liquid Fraction and Condensation Loss in Steam Turbines
  66. Selected papers from the 16th UK heat transfer conference (UKHTC2019)
  67. Energy efficiency and exergy destruction of supersonic steam ejector based on nonequilibrium condensation model
  68. Wet steam flow and condensation loss in turbine blade cascades
  69. Numerical simulation of nanodroplet generation of water vapour in high-pressure supersonic flows for the potential of clean natural gas dehydration
  70. Optimisation of the fuelling of hydrogen vehicles using cascade systems and ejectors
  71. Polydispersed droplet spectrum and exergy analysis in wet steam flows using method of moments
  72. Advances in Heat Transfer and Thermal Engineering
  73. Steam ejector performance considering phase transition for multi-effect distillation with thermal vapour compression (MED-TVC) desalination system
  74. Optimisation study of a supersonic separator considering nonequilibrium condensation behaviour
  75. Feature Extraction of Oscillating Flow With Vapor Condensation of Moist Air in a Sonic Nozzle
  76. Performance of steam ejector with nonequilibrium condensation for multi-effect distillation with thermal vapour compression (MED-TVC) seawater desalination system
  77. Numerical optimization of a novel gas-gas ejector for fuelling of hydrogen vehicles
  78. Prediction of dehydration performance of supersonic separator based on a multi-fluid model with heterogeneous condensation
  79. Non-equilibrium condensation of water vapour in supersonic flows with shock waves
  80. A first study of the potential of integrating an ejector in hydrogen fuelling stations for fuelling high pressure hydrogen vehicles
  81. Numerical modelling of non-equilibrium condensation of carbon dioxide (CO2) in a converging-diverging nozzle
  82. Sand Transport and Deposition Behaviour in Subsea Pipelines for Flow Assurance
  83. Entropy generation and exergy destruction in condensing steam flow through turbine blade with surface roughness
  84. Performance of supersonic steam ejectors considering the nonequilibrium condensation phenomenon for efficient energy utilisation
  85. An efficient approach to separate CO2 using supersonic flows for carbon capture and storage
  86. Gas-liquid two-phase flow behavior in terrain-inclined pipelines for gathering transport system of wet natural gas
  87. Droplet behavior of non-equilibrium condensation in the supersonic separator
  88. Understanding the formation process of the liquid slug in a hilly-terrain wet natural gas pipeline
  89. Gas-liquid two-phase flows in double inlet cyclones for natural gas separation
  90. CFD modeling of condensation process of water vapor in supersonic flows
  91. CFD modeling of particle behavior in supersonic flows with strong swirls for gas separation
  92. Optimization of static vanes in a supersonic separator for gas purification
  93. Effect of delta wing on the particle flow in a novel gas supersonic separator
  94. Effect of swirling device on flow behavior in a supersonic separator for natural gas dehydration
  95. Experimental Study on Alternating Current Corrosion of Pipeline Steel in Alkaline Environment
  96. Experimental study on stray current corrosion of coated pipeline steel
  97. Numerical simulation of real gas flows in natural gas supersonic separation processing
  98. Theoretical and numerical analysis on pressure recovery of supersonic separators for natural gas dehydration
  99. Effect of Inlet and Outlet Flow Conditions on Natural Gas Parameters in Supersonic Separation Process
  100. Prediction of Mass Flow Rate in Supersonic Natural Gas Processing
  101. The swirling flow structure in supersonic separators for natural gas dehydration
  102. EFFECTS OF ALTERNATING CURRENT ON XTO STEEL MORPHOLOGY AND ELECTROCHEMICAL BEHAVIOR
  103. Evaluation of natural gas dehydration in supersonic swirling separators applying the Discrete Particle Method
  104. Numerical simulation of natural gas flows in diffusers for supersonic separators
  105. Swirling Effects on the Performance of Supersonic Separators for Natural Gas Separation
  106. Swirling flow of natural gas in supersonic separators
  107. Supersonic swirling characteristics of natural gas in convergent-divergent nozzles
  108. Optimization Design of Diffusers for Supersonic Separators